Key points are not available for this paper at this time.
Abstract Background Precise and accurate measurements of blood gases are important for the diagnosis, monitoring and treatment of respiratory, metabolic, and acid-base disturbances. This study demonstrates the precision of the pH, partial pressure of oxygen (PO2), and partial pressure of carbon dioxide (PCO2) tests in the i-STAT G3+ cartridge with the i-STAT 1 System in arterial, venous, and capillary whole blood specimens in point-of-care or clinical laboratory settings. Methods The precision of the i-STAT pH, PO2, and PCO2 tests in the i-STAT G3+ cartridge was assessed at external clinical sites by end-users using whole blood specimens across the measurement range for each test: pH (6.500 - 7.800 pH units), PO2 (5 - 700 mmHg), PCO2 (5.0 - 130.0 mmHg). The study included venous whole blood samples from ∼140 adult subjects (≥ 18 years) and arterial whole blood samples from ∼140 adult subjects at 3 clinical sites. Each whole blood sample was run in duplicate on the i-STAT G3+ cartridge. In addition, ∼140 specimens were collected in capillary tubes using two fingerstick draws from adult subjects and ∼20 capillary heel-stick specimens were collected into two capillary tubes from neonate subjects (birth - 28 days) at two clinical sites. Specimens used in this study were prospectively collected venous, arterial, or capillary specimens under an Institutional Review Board approved informed consent or were de-identified leftover venous or arterial specimens. For each specimen type, duplicates from each subject were grouped into subintervals based on their mean values. The subintervals included the medical decision levels of 7.300, 7.350 and 7.450 pH units for pH, 30, 45 and 60 mmHg for PO2 and 35, 45, 50 and 70 mmHg for PCO2. The estimates of the pooled standard deviation (SD) and pooled coefficient of variation (%CV), as well as their respective 95% confidence intervals were calculated for each subinterval. Results Across all specimen types (excluding outliers), the pooled SD for pH ranged from 0.00591 - 0.01747 pH units for subintervals 6.500 - 7.300, 7.300 - 7.450, 7.450 - 7.800 pH units. For PO2, the pooled SD ranged from 0.71 - 3.76 mmHg for subintervals 10 - 40 mmHg and 40 - 50 mmHg and the pooled %CV ranged from 1.63 - 8.76 %CV for subintervals 50 - 100 mmHg, 100 - 250 mmHg and 250 - 700 mmHg. For PCO2, the pooled SD ranged from 0.000 - 1.709 mmHg for subintervals 5.0 - 35.0 mmHg, 35.0 - 50.0 mmHg and 50.0 - 62.5 mmHg and the pooled %CV ranged from 1.10 - 3.62 %CV for subinterval 62.5 - 130.0 mmHg. Conclusions The precision study demonstrated that the pH, PO2 and PCO2 tests in the i-STAT G3+ cartridge when tested using the i-STAT 1 System deliver precise results within ∼2 minutes for venous, arterial, and capillary whole blood patient specimens when tested by end users in a point-of-care or clinical laboratory setting. These studies were funded by Abbott Laboratories.
Thibodeau et al. (Tue,) studied this question.