Key points are not available for this paper at this time.
This research investigated the effect of ion concentration on the performance of low salinity water under different conditions. First, the effect of injection water composition on interparticle forces in quartz-kaolinite, kaolinite-kaolinite, and quartz-oil complexes was tested and modeled. The study used two oil samples, one with a high total acid number (TAN) and the other with a low TAN. The results illustrated that reducing the concentration of divalent ions to 10 mM resulted in the electric double layer (EDL) around the clay and quartz particles and the high TAN oil droplets, expanding and intensifying the repulsive forces. Next, the study investigated the effect of injection water composition and formation oil type on wettability and oil/water interfacial tension (IFT). The results were consistent with the modeling of interparticle forces. Reducing the divalent cation concentration to 10 mM led to IFT reduction and wettability alteration in high TAN oil, but low TAN oil reacted less to this change, with the contact angle and IFT remaining almost constant. Sandpack flooding experiments demonstrated that reducing the concentration of divalent cations incremented the recovery factor (RF) in the presence of high TAN oil. However, the RF increment was minimal for the low TAN oil sample. Finally, different low salinity water scenarios were injected into sandpacks containing migrating fines. By comparing the results of high TAN oil and low TAN oil samples, the study observed that fine migration was more effective than wettability alteration and IFT reduction mechanisms for increasing the RF of sandstone reservoirs.
Kazemi et al. (Fri,) studied this question.