Key points are not available for this paper at this time.
Introduction Toward further cerebro-spinal flow quantification in clinical practice, this study aims at assessing the variations in the cerebro spinal fluid flow pattern associated with change in the morphology of the subarachnoid space of the cervical canal of healthy humans by developing a computational fluid dynamics model. Methods 3D T2-space MRI sequence images of the cervical spine were used to segment 11 cervical subarachnoid space. Model validation (time-step, mesh size, size and number of boundary layers, influences of parted inflow and inflow continuous velocity) was performed a 40-year-old patient-specific model. Simulations were performed using computational fluid dynamics approach simulating transient flow (Sparlart-Almaras turbulence model) with a mesh size of 0.6, 6 boundary layers of 0.05 mm, a time step of 20 ms simulated on 15 cycles. Distributions of components velocity and WSS were respectively analyzed within the subarachnoid space (intervertebral et intravertebral levels) and on dura and pia maters. Results Mean values cerebro spinal fluid velocity in specific local slices of the canal range between 0.07 and 0.17 m.s -1 and 0.1 and 0.3 m.s -1 for maximum values. Maximum wall shear stress values vary between 0.1 and 0.5 Pa with higher value at the middle of the cervical spine on pia mater and at the lower part of the cervical spine on dura mater. Intra and inter-individual variations of the wall shear stress were highlighted significant correlation gwith compression ratio (r = 0.76), occupation ratio and cross section area of the spinal cord. Conclusion The inter-individual variability in term of subarachnoid canal morphology and spinal cord position influence the cerebro-spinal flow pattern, highlighting the significance of canal morphology investigation before surgery.
Leblond et al. (Mon,) studied this question.