Key points are not available for this paper at this time.
In wireless communications as well as in structural health monitoring (SHM) beam steering presents interesting advantages. In the former it plays an important role for data directivity, which is also a perk for energy efficiency and data security; for the latter, directional inspection through guided waves leads also to energy efficiency, arbitrary dedicated space scanning, multi-function operation through multiple beams and even to application of a base-line free inspection concept. Normally, to enable this simultaneous beam control and data communication in arbitrary spatial directions (2D) over a structure, a large array of transducers is required, arranged to a similarly complex hardware and software support system. In this work, we present a system based on a dedicated sensor node (SN) and frequency steerable acoustic transducer (FSAT) combination. The SN-FSAT system is charged of the adequate power and signal management for acquisition, transmission, processing and data evaluation, required to perform spatial scanning and damage detection, as well as direction focused wireless communication tasks. These were tested over an isotropic aluminum plate-like structure by means of a double symmetric beam, via differential actuation signals, or in a high directive beam in a single direction by means of a quadrature driving signals. The complete guided wave-based setup consists of three SN-FSAT pairs. As damage a pseudo fault of a small added mass with damping tacky tape was used. The results show that damage located in different positions around the FSATs can be detected without a baseline reference and multiple directional communication paths between the SN-FSAT network can be established.
Reyes et al. (Sat,) studied this question.