Key points are not available for this paper at this time.
Abstract Thermoplastic composite pipe is gaining popularity in the oil and gas and renewable energy industries as an alternative to traditional metal pipe mainly due to its capability of being spooled onto a reel and exceptional corrosion resistance properties. Despite its corrosion-proof nature, this material remains susceptible to various defects, such as delamination, fiber breakage, matrix degradation and deformation. This study employed the phased array ultrasonic testing technique with the implementation of the classical time-corrected gain method to compensate for the significant spatial signal attenuation beyond the first interface layer in the thick multi-layered thermoplastic composite pipe. Initially, the ultrasonic signals from the interface layers and back wall were detected with good signal-to-noise ratios. Subsequently, flat-bottom holes of varying depths, simulating one-sided delamination, were bored and the proposed method effectively identified ultrasonic signals from these holes, clearly distinguishing them from the background noise and interface layer signals. Finally, a defect deliberately fabricated within the composite laminate layers during the pipe manufacturing process was successfully identified. Subsequently, this fabricated defect was visualized in a three-dimensional representation using the X-ray computed tomography for a qualitative and quantitative comparison with the proposed ultrasonic method, showing a high level of agreement.
Tahir et al. (Fri,) studied this question.