Disagreements in Geodetically Inferred Strain Rates in the Western US With Stress Orientations and Geologic Moment Rates

Abstract I employ an elasticity‐based method to invert a geodetically derived surface velocity field in the western US using for present‐day surface strain rate fields with uncertainties. The method uses distributed body forces in a thin elastic sheet and allows for discontinuities in velocity across creeping faults using the solution for dislocations in a thin elastic plate. I compare the strain rate fields with previously published stress orientations and moment rates from geological slip rate data and previous geodetic studies. Geologic and geodetic moment rates are calculated using slip rate and off‐fault strain rates from the 2023 US National Seismic Hazard Model (NSHM) deformation models. I find that computed total geodetic moment rates are higher than NSHM summed moment rates on faults for all regions of the western US except the highest deforming rate regions including the Western Transverse Ranges and the northern and southern San Andreas Fault (SAF) system in California. Computed geodetic moment rates are comparable to the moment rates derived from the geodetically based NSHM deformation models in all regions. I find systematic differences in orientations of maximum horizontal shortening rate and maximum horizontal compressive stress in the Pacific Northwest region and along much of the SAF system. In the Pacific Northwest, the maximum horizontal stress orientations are rotated counterclockwise 40–90° relative to the maximum horizontal strain rate directions. Along the SAF system, the maximum horizontal stresses are rotated systematically 25–40° clockwise (closer to fault normal) relative to the strain rates.