Key points are not available for this paper at this time.
The wet electrostatic precipitator (WESP) overcomes the shortcomings of traditional electrostatic precipitators, such as dust re-entrainment and back corona. It can effectively remove high-specific-resistivity dust, with a good removal effect on PM2.5. It is proposed to adopt chemical agglomeration and humidification agglomeration technology in the wet electrostatic precipitators to achieve ultra-low dust emissions from coal-fired power plants. The results show that the addition of chemical agglomerates, surfactants, and water vapor all affect the dust diameter of coal-fired power plants. After adding sesbania gum (SG), the D50 of dust particles increases from 28.29 μm to 48.22 μm. And the D50 of dust particles is 36.46 μm when spraying 3.6 kg/h water vapor only. With the cooperation of chemical agglomeration agents and water vapor, the dust agglomeration effect and removal efficiency can be further improved. When 10 mg/L SG is synergistically combined with 2.9 kg/h water vapor, the D50 is 64.75 μm, and the dust removal efficiency reaches 97.88%. On this basis, by adding 5 mg/L of Hexadecyltrimethylammonium bromide (CTAB), the D50 is 83.06 μm, and the dust removal efficiency increases to 98.62%. The synergistic effect of chemical agglomeration and humidification agglomeration promotes the aggregation of dust from coal-fired power plants. It can improve the removal efficiency of WESP for fine particulate matter but has little impact on the operation of existing equipment. The synergistic effects of multiple agglomeration technologies are also the direction for future research on the removal efficiency of fine particulate matter.
Chen et al. (Sun,) studied this question.