Multi-laser powder bed fusion is an emerging additive manufacturing technology that enables the production of high-performance components with intricate geometries and large aspect ratios. These tall, slender structures are highly susceptible to steep thermal gradients and residual stress, leading to deformation that compromises dimensional accuracy and structural integrity. This study investigates how geometric compensation, support structure design, and part scaling influence thermal deformation in Inconel 718 components fabricated via multi-laser powder bed fusion. Using pre-compensation, iterative support refinements, and scaled experimental builds, the deformation response across multiple geometries and print strategies is evaluated. Both compensated and original designs are printed on a commercial system equipped with three simultaneously operating lasers. Results show that printing high-angle surfaces without support structures is infeasible, as thermally induced warping and delamination lead to catastrophic failures. Conical support structures spanning critical regions reduce deformation by more than 50% compared to unsupported builds. Reduced-scale parts, however, do not reliably replicate full-scale deformation behavior due to altered boundary conditions and thermal pathways. These findings highlight the need for integrated design-for-AM workflows where compensation, support design, and scale effects are addressed jointly. The study demonstrates that deformation mechanisms do not scale linearly, emphasizing the limitations of small-scale proxies and the necessity of full-scale validation when developing reliable, deformation-aware design strategies for multi-laser powder bed fusion.
Raut et al. (Thu,) studied this question.