Structural health monitoring (SHM) technology enables the monitoring and assessment of the condition of various materials and structures. Lamb-guided waves (LW) are widely used to detect damage in large-scale plate structures. One of the parameters used for these purposes is the time-of-flight (ToF) of ultrasonic LW signals. In the presented feasibility study, the ToF was determined based on the idea that the zero-crossings of this signal, filtered by several filters, are concentrated around the maximum of the signal envelope. This ToF detection method, unlike threshold- and peak-based methods, avoids uncertainties in signal and noise levels and does not require a signal detection threshold. Compared to the correlation method, no reference signal is required. It has been established that the curves of signal propagation times with varying distance depend on the group and phase velocities of signal propagation and have phase jumps. The proposed methodology for assessing plate inhomogeneities involves comparing signal propagation time curves with and without damage. This methodology has been verified both through theoretical modeling and experimental research. The experimental studies used a 6 mm thick steel specimen with artificial defects of various diameters (10–35 mm). The A0 mode of Lamb waves with a central frequency of 150 kHz was excited in the steel plate. For experimentally obtained B-scans, the ToF distributions of signals along the scan trajectories were calculated. By comparing the defective and defect-free ToF curves, critical points of the experimental curves were determined, which were used to estimate the dimensions of the defects. Both in the case of theoretical modeling and in the result of experimental measurements, it was determined that the proposed methodology can be used to determine the inhomogeneities of plates.
Olgirdas Tumšys (Mon,) studied this question.