Key points are not available for this paper at this time.
The design of air-to-air, thrust augmenting ejectors having short curved wall diffuses utilizing boundary layer control is discussed. The design is achieved by an inverse method which uses the vorticity at the diffuser inlet as a flow parameter in the analysis. Three diffusers having ejector length-to-mixing chamber diameter ratios of approximately 6:1 and mixing chamber inlet area-to-primary nozzle area ratios of 20:1 and 40:1 were designed and tested. A new high level of performance was analytically predicted and achieved experimentally. Comparisons between predicted and observed performances, velocity distributions and pressure distributions are presented.
Yang et al. (Fri,) studied this question.