On morphology and roughness of upskin surfaces in laser powder-bed fusion additive manufacturing – Contouring strategy effects

The surface quality of inclined parts made by Laser powder-bed fusion (L-PBF) additive manufacturing is inferior to those made by conventional formative and subtractive manufacturing techniques. The inherited step edges formed during such layer-by-layer fabrications and partially melted or non-melted particles attached to the newly formed surface are the major causes of poor surface finish of L-PBF parts. This study is a part of a research framework, in which the effects of different contouring strategies and scan parameters on the surface morphology of inclined parts are investigated by both experimental and numerical methods. In particular, the effect of two different contour scan strategies, namely pre-contouring and post-contouring, on the upskin surface roughness of 30⁰ inclined parts is analyzed. The inclined specimens were fabricated with Ti6Al4V powder using an EOS M270 system and the upskin surfaces were measured by a white light interferometer. In addition, a multi-track multi-layer numerical approach using coupled discrete element method and thermo-fluid simulation was also performed to understand the inclined surface formation in L-PBF. The findings show that the pre-contouring strategy with high linear energy density (LED) (0.4 J/mm) results in average surface roughness (S a ) as low as 7.43 µm, whereas the lowest LED (0.05 J/mm) resulted in the highest S a of 33.74 µm. Larger melt pool dimensions were obtained in the high LED pre-contouring simulations, which indicates a better material fusion resulting in a good surface finish. The numerical simulation showed that the upskin surface roughness is also affected by the raster scan, if the raster scanning LED is higher than that of pre-contour scans. For the post-contouring strategy studied, higher and lower LEDs were used in inner and outer contour scanning, respectively. It is indicated that the inner contour scanning with a high LED reduces the surface roughness because of a larger melt pool size, irrespective of outer contour scanning. The lowest S a obtained was 8.24 µm for the highest LED inner contour (0.05 J/mm) case and the highest S a was 19.95 µm, for the parts made with the lowest LED inner contour scan (0.075 J/mm) strategy. The coupled discrete-element and thermo-fluid-based simulations offer insights into the sloped surface formation and the results supported the experimental findings in qualitative manner.