CT Measurements of Lung Density in Life Can Quantitate Distal Airspace Enlargement—An Essential Defining Feature of Human Emphysema

We used a computerized microscopic image analysis system to directly measure the surface area of distal air spaces in methacrylate-embedded blocks randomly selected from inflation-fixed lobes that were resected from 45 patients as treatment of their peripheral lung tumors. In 28 of these patients, a preoperative computer tomography (CT) scan, at 6 and 10 cm below the sternal notch, was used to generate frequency histograms of CT numbers (measured as EMI units), a measure of lung density, in pixels from the lung or lobe that was subsequently resected. A similar CT number histogram was also derived from the lateral two fifths of the area of lobe/lung that was to be resected. The EMI unit that defined the lowest fifth percentile of this latter histogram correlated (n = 28, r = -0.77, p less than 0.001) with the mean value of the surface area of the walls of distal airspaces per unit lung volume (AWUV) in the five 1 mm x 1 mm microscopic fields with the lowest AWUV values, out of the 20 to 35 such fields examined in each patient. In the 34 of the 45 patients in whom we also measured volume-corrected diffusing capacity (DLCO/VA), this also correlated (n = 34, r = 0.84, p less than 0.001) with this value of AWUV, which measures the surface area of airspaces distal to the terminal bronchioles--reflecting an increase in airspace size, a defining characteristic of emphysema. However, a low DLCO/VA is nonspecific, whereas an abnormally low regional lung density is more likely to be specific for emphysema. In addition, highlighting those pixels of the CT display with low CT numbers (i.e., EMI units -500 air to -450, where zero = water) can locate areas of macroscopic emphysema, as shown by subsequent pathologic examination. Thus the quantitative CT scan can diagnose, quantitate, and locate mild to moderate emphysema, in humans, in life, noninvasively.