Key points are not available for this paper at this time.
PURPOSE: To measure the variations in length during flexion and internal tibial rotation of the 3 different femoral insertions of the anterolateral ligament (ALL) while maintaining a fixed tibia insertion. METHODS: Twelve fresh-frozen cadaver knees were analyzed using a navigation system. Maximal distance variations of the 3 different anatomic femoral insertions of the ALL were measured during knee flexion and internal tibial rotation at 20° (IR20°) and 90° (IR90°). The 3 different femoral attachments were, as published, at the center of the lateral epicondyle, distal and anterior from this position, and proximal and posterior. Each of these 3 femoral insertions was coupled to the same tibial insertion at the tibial margin, halfway between the tip of the fibular head and the prominence of the Gerdy tubercle. RESULTS: During IR20°, variation in the distance between paired points is not different between the proximal-posterior, epicondyle, and distal-anterior femoral insertions. These variations were statistically different during IR90° for the 3 different femoral locations. In increasing degrees of flexion, there was a length decrease between paired points observed with the proximal-posterior position. A length increase was observed for both the epicondyle location and the distal-anterior location. CONCLUSIONS: The ALL did not reveal an isometric behavior at any of the femoral insertion locations but had different length change patterns during knee flexion and internal tibial rotation at 90°. The proximal and posterior to epicondyle femoral position is the only position with a favorable isometry, as shown by being tight in extension and in internal rotation at 20° and then relaxed when the knee goes to flexion at 120° and during internal rotation at 90°. CLINICAL RELEVANCE: Clinical relevance is significant with respect to optimizing the femoral position of an ALL reconstruction.
Imbert et al. (Wed,) studied this question.