The growing demand for offshore oil and gas production in deep waters has motivated the development of technologies to enable the continuous, reliable, and cost-effective monitoring of subsea equipment. Traditional inspection techniques rely on ROVs and AUVs, leading to delays between data acquisition and recovery and high operational costs. Underwater acoustic communication systems represent an attractive alternative for transmitting monitoring data to the surface in real time. This work evaluates the feasibility of implementing an underwater acoustic communication link for data transmission in deep-water environments, considering environmental conditions and acoustic channel characteristics. Using the BELLHOP ray-tracing model, simulations were performed to predict transmission loss, multipath effects, ambient noise, and the resulting signal-to-noise ratio (SNR) for different modem configurations and operating frequencies. The results demonstrate that the performance of the underwater link is strongly dependent on frequency, distance, and environmental variability. The study identifies optimal frequency–range relationships, quantifies the limitations imposed by transmission loss and ambient noise, and provides guidance for selecting acoustic modem parameters for real subsea monitoring applications. The SNR for three modem models operating at different frequencies illustrates the signal detection capability in the marine environment. The differences between modems A, B, and C are defined by their technical specifications and how they perform within the underwater acoustic channel of the Campos Basin. The data transmission capacity is supported by the data rates provided by the analyzed modems. The low frequencies of modem A (9.75 kHz) achieve the highest SNR, enabling long-range monitoring. At higher frequencies, modem C (78 kHz) allows short-distance communication. Modem B (35 kHz) offers a good balance between the data rate and power consumption, consuming only 1 W, making it highly viable for monitoring systems that rely on batteries and require long-term operation. The findings support the feasibility of integrating underwater acoustic communication into subsea monitoring architectures, enabling a more efficient oversight of deep-water production systems. The analysis concludes that project viability depends on selecting a system where the SNR and range meet the specific monitoring requirements.
Ribeiro et al. (Tue,) studied this question.