Evaluation of the performance of a 7‐T 8 × 2 transceiver array

Abstract The decoupled 8 × 2 transceiver array has been shown to achieve a mean B 1 + of 11.7 uT with a coefficient of variation of ~11% over the intracranial brain volume for 7‐T MR imaging. However, this array may be thought to give lower signal‐to‐noise ratio (SNR) and higher g‐factors for parallel imaging compared with a radio frequency (RF) receive‐only coil due to the latter's higher coil count and use of coil overlap to reduce the mutual impedance. Nonetheless, because the transceiver's highly decoupled design (pertinent for transmission) should also be constructive for reception, we measured the noise correlation, g‐factors, and SNR for the decoupled transceiver in comparison with a commercial reference coil. We found that although the transceiver has half the number of receive elements in comparison with the reference coil (16 vs. 32), comparable g‐factors and SNR over the head were obtained. From five subjects, the transceiver versus reference coil SNR was 65 ± 10 versus 67 ± 15. The mean noise correlation for all coil pairs was 10% ± 5% and 12% ± 9% (transceiver and reference coil, respectively). As changes in load impedance may alter the S parameters, we also examined the performance of the transceiver with tuned and matched (TM) versus untuned and unmatched (UTM) conditions on five subjects. We found that the noise correlation and SNR are robust to load variation; a noise correlation of 10% ± 5% and 10% ± 6% was determined with TM versus UTM conditions (SNR UTM /SNR TM = 0.97 ± 0.08). Finally, we demonstrate the performance of the array in human brain using T2‐weighted turbo spin echo imaging, finding excellent SNR performance in both caudal and rostral brain regions.