Snow accumulation and ice formation can significantly reduce pavement friction, posing a serious threat to traffic safety during winter. Traditional snow-removal methods, including mechanical removal, chemical de-icing agents, and heated pavement systems, suffer from several limitations such as low efficiency, environmental impacts, and high operational costs. Electrically conductive asphalt concrete (ECAC) has therefore emerged as a promising active snow-melting technology. When an electric current passes through the conductive network formed within the asphalt mixture, heat is generated through the Joule heating effect. After incorporating conductive fillers, the electrical resistivity of ECAC mixtures can be reduced from approximately 106–108 Ω·cm for conventional asphalt mixtures to about 10−1–102 Ω·cm. Under an applied voltage typically ranging from 30 to 60 V, ECAC pavements can increase the surface temperature by 10–30 °C within 10–30 min, thereby enabling rapid snow melting and ice removal. Meanwhile, an optimized conductive network can maintain sufficient mechanical performance, with dynamic stability generally exceeding 3000 cycles/mm. When the conductive filler content is reasonably controlled, only a limited reduction in fatigue resistance is observed. This paper presents a comprehensive review of electrically conductive asphalt concrete technologies for snow-melting pavements. The background, underlying mechanisms, material development, system configuration, and field applications of ECAC are systematically summarized. Finally, the current challenges are discussed, including the stability of conductive networks, the trade-off between electrical conductivity and pavement performance, and electrical safety. Future research directions focusing on material optimization, intelligent power control, and long-term field performance evaluation are proposed to support the practical application of ECAC pavements in sustainable winter road maintenance.
Liu et al. (Fri,) studied this question.