The global transition towards sustainable food systems has intensified the search for alternative protein sources that can meet human nutritional demands with reduced environmental impacts. Although microalgae are rich in protein, their applications in food remain limited due to thick cell walls and intense green color. The aim of this study is to modify Chlorella vulgaris by high-pressure homogenization (HPH) and decolorization to improve its processability for extrusion-based 3D printing. Microalgal biomass was pretreated by HPH at different pressures (10,000, 15,000, 20,000 psi) for one to three passes, followed by pigment removal using ethanol of different concentrations (70, 85, 100%). Microscopic imaging shows that HPH effectively disrupted microalgal cell walls and caused cell disintegration, resulting in increased foaming stability (22–28%) but lower solubility (up to 24%), with other functional properties largely preserved. Ethanol treatments markedly decolored microalgae and increased their water-holding capacity (10–45%) and solubility (6–11%). The formulation of HPH-treated decolorized microalgae with soy protein isolate and xanthan gum increased the viscosity (66–179%) and elasticity (78–235%) of printing inks. The resulting 3D prints show higher hardness (47–128%), springiness (up to 155%) and chewiness (47–408%). The information obtained from this study provides guidance for modifying the functional and rheological properties of microalgae and contributes to advancing the formulation and manufacturing of microalgae-based foods.
Sinclair et al. (Fri,) studied this question.