Background: Surface roughness in turning operations is still verified predominantly after machining, which limits the possibility of timely corrective intervention. Methods: This study examined whether normal-direction peak-to-peak vibration displacement can serve as a practical low-frequency indicator of surface roughness during finish turning of EN AW-2011 aluminum alloy. The analysis was based on 190 synchronized displacement-roughness observation pairs obtained in one controlled experimental campaign on a CQ6230 conventional precision lathe, using a VB-8206SD displacement logger mounted radially on the tool holder and contact profilometry measurements reported as Ra and Rz. The analytical workflow included explicit quality-control safeguards for malformed rows, missing values, and obvious artefacts; in the present dataset, these checks did not indicate a failure state that would invalidate the main calculations. The workflow combined descriptive statistics, moving-average trend inspection, low-frequency FFT and STFT descriptors, Pearson correlation analysis, and ordinary least squares regression. Results: The displacement signal exhibited a mean value of 0.0446 mm with a standard deviation of 0.0256 mm and showed strong within-dataset linear relations with roughness parameters: Ra = 14.204 + 24.191 V (R2 = 0.9929, RMSE = 0.052 µm) and Rz = 63.207 + 105.253 V (R2 = 0.9905, RMSE = 0.264 µm). Conclusions: The results support setup-specific roughness-related process-state assessment using low-rate normal-direction displacement measurements. However, because the 190 records represent a time-ordered synchronized sequence rather than 190 independent cutting trials, and because no separate validation set was available, the fitted equations should be interpreted as descriptive within-setup calibration rather than as universally validated predictive models.
Jackuvienė et al. (Fri,) studied this question.