A multi-parametric process evaluation of the mechanical response of PLA in FFF 3D printing

Polylactic acid (PLA) material in filament form can be 3D printed and form complex physical models by using a low-cost material extrusion mechanism in a process that is broadly known as fused filament fabrication (FFF). Even though the PLA-FFF process has been extensively studied in the literature, its parts’ mechanical response varies significantly, and it has not been studied in association with six control parameters at the same time, i.e. the infill density (ID), raster deposition angle (RDA), nozzle temperature (NT), printing speed (PS), layer thickness (LT), and bed temperature (BT). The simultaneous influence of the variable parameters on the mechanical properties is a challenging assignment and aspires to rank the six parameters’ importance, model the process, and finally validate the models by using independent experiments. One-hundred twenty-five experiments run following the Taguchi L25 orthogonal array repeated five times for the study purpose. After an extensive literature survey and preliminary experiments, the parameter selection and discrete values were selected. The experimental results were analyzed using statistical tools and critically compared with that of the literature. The RDA, NT, PS, and ID significantly impact the mechanical response of the 3D printed PLA parts.