Estimating soil water content in a thorny forest ecosystem by time‐lapse electrical resistivity tomography (ERT) and HYDRUS 2D/3D simulations

Abstract Determination of soil volumetric water content in forest ecosystems is particularly challenging due to deep rooting systems and unknown soil vertical and spatial heterogeneity. This research aims to test two undisturbed methods, electrical resistivity tomography (ERT) and HYDRUS 2D/3D, for 2D determination in a thorny forest ecosystem. The experiment consisted of infiltrating 10 L of water lasting 60 min. During infiltration, ERT measured apparent resistivity by time‐lapse measurements, and was measured with an FDR probe (EnviroSCAN) at 33, 63, 83, 97, and 163 cm depth close to the infiltration site. At the end of infiltration, a soil pit was dug, and 100 measurements of were performed with a TDR in a 10 × 10 cm regular grid. Archie law transformed soil resistivity (ERT) into using manual calibration, verified by an independent dataset. The 2D profile obtained by ERT was qualitatively compared with the HYDRUS 2D/3D one. HYDRUS 2D/3D was parametrized with calibrated parameters obtained with HYDRUS 1D using 106 days of obtained with EnviroSCAN. The results of HYDRUS 1D calibration and verification were satisfactory, with RMSE and Nash‐Sutcliffe coefficients ranging from 0.021 to 0.034 cm 3 cm −3 and 0.11 to 0.77, respectively. The forward HYDRUS 2D/3D simulation disagrees with EnviroSCAN data for 33 cm depth. However, it follows the trend with near to zero variation of water content at 63 cm depth. Water content determination by ERT was satisfactory with RMSE for calibration and verification of 0.017 and 0.021 cm 3 cm −3 . HYDRUS 2D/3D and ERT comparisons were not equal, with a shallower wetting front by ERT and a deeper one for HYDRUS. Still, both wetting fronts agree with the wetting depth estimated by EnviroSCAN. We conclude that both methods are an alternative for determination in heterogeneous and deep soils of forest ecosystems.