Earthquake triggering by transient and static deformations

Observational evidence for both static and transient near‐field and far‐field triggered seismicity are explained in terms of a frictional instability model, based on a single degree of freedom spring‐slider system and rate‐ and state‐dependent frictional constitutive equations. In this study a triggered earthquake is one whose failure time has been advanced by Δ t (clock advance) due to a stress perturbation. Triggering stress perturbations considered include square‐wave transients and step functions, analogous to seismic waves and coseismic static stress changes, respectively. Perturbations are superimposed on a constant background stressing rate which represents the tectonic stressing rate. The normal stress is assumed to be constant. Approximate, closed‐form solutions of the rate‐and‐state equations are derived for these triggering and background loads, building on the work of Dieterich 1992, 1994. These solutions can be used to simulate the effects of static and transient stresses as a function of amplitude, onset time t 0 , and in the case of square waves, duration. The accuracies of the approximate closed‐form solutions are also evaluated with respect to the full numerical solution and t 0 . The approximate solutions underpredict the full solutions, although the difference decreases as t 0 approaches the end of the earthquake cycle. The relationship between Δ t and t 0 differs for transient and static loads: a static stress step imposed late in the cycle causes less clock advance than an equal step imposed earlier, whereas a later applied transient causes greater clock advance than an equal one imposed earlier. For equal Δ t , transient amplitudes must be greater than static loads by factors of several tens to hundreds depending on t 0 . We show that the rate‐and‐state model requires that the total slip at failure is a constant, regardless of the loading history. Thus a static load applied early in the cycle, or a transient applied at any time, reduces the stress at the initiation of failure, whereas static loads that are applied sufficiently late raise it. Rate‐and‐state friction predictions differ markedly from those based on Coulomb failure stress changes (ΔCFS) in which Δ t equals the amplitude of the static stress change divided by the background stressing rate. The ΔCFS model assumes a stress failure threshold, while the rate‐and‐state equations require a slip failure threshold. The complete rate‐and‐state equations predict larger Δ t than the ΔCFS model does for static stress steps at small t 0 , and smaller Δ t than the ΔCFS model for stress steps at large t 0 . The ΔCFS model predicts nonzero Δ t only for transient loads that raise the stress to failure stress levels during the transient. In contrast, the rate‐and‐state model predicts nonzero Δ t for smaller loads, and triggered failure may occur well after the transient is finished. We consider heuristically the effects of triggering on a population of faults, as these effects might be evident in seismicity data. Triggering is manifest as an initial increase in seismicity rate that may be followed by a quiescence or by a return to the background rate. Available seismicity data are insufficient to discriminate whether triggered earthquakes are “new” or clock advanced. However, if triggering indeed results from advancing the failure time of inevitable earthquakes, then our modeling suggests that a quiescence always follows transient triggering and that the duration of increased seismicity also cannot exceed the duration of a triggering transient load. Quiescence follows static triggering only if the population of available faults is finite.