Key points are not available for this paper at this time.
The area burned by wildfires in Canada in 2023 is unprecedented in historical records. To help ensure the safety of communities and support the mobilization of firefighting resources, rapid detection of areas affected by wildfires is required. Satellite data are ideally suited to provide near real-time wildfire information over large areas. At the same time, clouds, smoke, and haze can obscure the collection of observations from sensors typically used for mapping purposes. Established methods using coarse spatial resolution satellites (e.g., MODIS, VIIRS) rely upon the combination of daily revisit to enable the rapid and reliable detection of large active fires, in full or in part, and the application of modeling (including spatial buffering) to infer additional, yet still obscured, areas. While timely, these initial maps of wildfire-impacted areas do not capture small fires (those smaller than 200 ha) and, importantly, are not intended to differentiate unburned areas within fire perimeters. To address these limitations, we used data from Sentinel-2A and -2B, and Landsat-8 and -9, which form a virtual constellation of four satellites to revisit and map burned area in Canada's forested ecosystems for the 2023 fire season. Availing upon the high temporal data density and using the Tracking Intra- and Inter-year Change algorithm (TIIC), an aggregate seasonal mapping of wildfires resulted in a total area affected by wildfires in 2023 of 12.74 Mha. Within this total area, 9.51 Mha of treed land cover was impacted. Shrubs and wetlands comprised most of the remaining non-treed area that was burned. Using a 2022 map of aboveground treed biomass (AGB), approximately 0.649 Pg of AGB was impacted by 2023 wildfires, representing an 11-fold increase in AGB impacts relative to a long-term annual average of treed AGB loss. Differences between the estimate of total burned area reported herein and the total burned area indicated by the Natural Resources Canada (NRCan) Fire M3 hotspot fire perimeters (18.64 Mha) were analyzed. Overall, estimates of burned area differed by 5.9 Mha, including over 1.13 Mha of water identified as burned within the NRCan perimeters. Differences in land cover and AGB impacts between the two products were also investigated and quantified. TIIC enables the near-continuous capture of areas impacted by fire through the fire season, allowing for within-year refinement of total burned area, rapid interrogation of land cover types impacted, and estimation of associated biomass consequences.
Pelletier et al. (Fri,) studied this question.