Thermoelectric generators (TEGs) enable compact waste-heat energy harvesting but require high-gain DC–DC conversion due to their low-output voltage for DC microgrid interfacing. This work proposes a novel TEG-supplied two-stage architecture consisting of a perturb-and-observe (P&O)-based MPPT boost converter followed by a modified Z-source converter regulated through an advanced model predictive control (MPC) framework. The modified Z-source topology enables high-voltage gain without extreme duty ratios and mitigates switching losses by eliminating diode reverse-recovery effects via synchronous operation. To enhance dynamic performance, the advanced MPC strategy incorporating an adaptive ripple-based weighting mechanism is applied to the modified Z-source converter and benchmarked against MPC and sliding mode control (SMC). Simulation results under multiple disturbance scenarios, including hot-side and cold-side temperature variations, multi-condition disturbances, coupling-factor variation, and measurement noise, demonstrate that the proposed system maintains stable 400 V regulation at a 100 W output level. In contrast, MPC exhibits switching frequency deviations that increase switching losses during transient operation, while SMC suffers from significant voltage deviations under source variations. The proposed strategy maintains tight voltage regulation with nearly fixed-frequency operation around 50 kHz, providing a new perspective for TEG researchers while supporting sustainable waste-heat energy utilization.
Mehmet Zahid Erel (Wed,) studied this question.