Key points are not available for this paper at this time.
The application of Unmanned Aerial Vehicles (UAVs), commonly known as drones, in geological, geomorphological, and geotechnical studies has gained significant attention due to their versatility and capability to capture high-resolution data from challenging terrains. This research uses drone-based high-resolution photogrammetry to assess the geomechanical properties and rockfall potential of several rock scarps within a wide area of 50 ha. Traditional methods for evaluating geomechanical parameters on rock scarps involve time-consuming field surveys and measurements, which can be hazardous in steep and rugged environments. By contrast, drone photogrammetry offers a safer and more efficient approach, allowing for the creation of detailed 3D models of a cliff area. These models provide valuable insights into the topography, geological structures, and potential failure mechanisms. This research processed the acquired drone imagery using advanced geospatial software to generate accurate orthophotos and digital elevation models. These outputs analysed the key factors contributing to rockfall triggering, including identifying discontinuities, joint orientations, kinematic analysis of failures, and fracturing frequency. More than 8.9 × 107 facets, representing discontinuity planes, were recognised and analysed for the kinematic failure modes, showing that direct toppling is the most abundant rockfall type, followed by planar sliding and flexural toppling. Three different fracturation grades were also identified based on the number of planar facets recognised on rock surfaces. The approach used in this research contributes to the ongoing development of fast, practical, low-cost, and non-invasive techniques for geomechanical assessment on vertical rock scarps. In particular, the results show the effectiveness of drone-based photogrammetry for rapidly collecting comprehensive geomechanical data valid to recognise the prone areas to rockfalls in vast regions.
Cirillo et al. (Mon,) studied this question.