Key points are not available for this paper at this time.
Miscanthus giganteus lignin was extracted by an organosolv process under reflux conditions (4 h) with varying concentrations of ethanol (65%, 75%, 85%, 95%) and 0.2 M hydrochloric acid as catalyst. The resulting lignin was extensively characterized by size exclusion chromatography (SEC), Fourier-transform infrared spectroscopy (FTIR), gas chromatography-mass spectrometry (GC/MS), two-dimensional nuclear magnetic resonance spectroscopy (2D-NMR), and chemical analysis (residual sugars, Klason lignin, ash). The predominant linkage units present were β-O-4' (82-84%), resinol (6-7%), and phenylcoumaran (10-11%). The 65% ethanol solvent system gave the lowest lignin yield (14% of starting biomass) compared to 29-32% of the other systems. Increasing ethanol concentration resulted in decreasing carbohydrate content of the lignins (3.6-1.1%), a higher solubility in tetrahydrofuran (THF), a slight reduction of the molecular weight (M(w) 2.72-2.25 KDa), an increasing α-ethoxylation, and an increase in ethoxylated phenylpropenoic compounds (p-coumaric and ferulic acid), but the S/G ratio of the monolignols (0.63, GC/MS) and Klason lignin content (86-88%) were unaffected. An extraction method for these ethyl-esterified phenylpropenoids and smaller molecular weight lignin compounds was developed. The effect of reaction time (2, 4, and 8 h) was investigated for the 95% ethanol solvent system. Besides increased lignin yield (13-43%), a slight increase in M(w) (2.21-2.38 kDa) and S/G ratio (0.53-0.68, GC-MS) was observed. Consecutive extractions suggested that these changes were not from lignin modifications (e.g., condensations) but rather from extraction of lignin of different composition. The results were compared to similar solvent systems with 95% acetone and 95% dioxane.
Bauer et al. (Mon,) studied this question.