Key points are not available for this paper at this time.
The extraction of petroleum fluids from sub-surface accumulations mandates the drilling of a well into the formation containing the accumulation. The drilling techniques have evolved over time to overcome several challenges while some of the issues still prevail with the currently used drilling practices like loss circulation, large tripping time to change bottom hole assembly, stuck pipe problems and low well bore stability, to name a few. These decrease the drilling efficiency and increase the Non-Productive Time (NPT) of this highly capital-intensive industry encouraging the Petroleum Industry to look for new technology. Casing while Drilling (CwD) is a technique of drilling which has been proven to alleviate many of the problems faced while drilling. In this method, drilling and casing of a well bore is carried out simultaneously, which improves the drilling efficiency by reducing the NPT. It has proven to be beneficial in controlling loss circulation and improving wellbore stability by ‘Plastering’ effect, high quality cement job and increased rig floor safety. It uses smaller rig and less fuel thereby reducing carbon footprint in the environment. This paper studies comprehensive well control and casing string design consideration. Economics encourages its application that has been discussed in the paper. A case study on the application of CwD in Malay basin for top hole drilling is presented. Finally, the paper briefly outlines the technical challenges that need attention to get better results from CwD. Keywords: Casing while drilling, Non productive time, Plastering effect, Well control
Patel et al. (Wed,) studied this question.