In mechanical material evaluation and biomechanical studies, Young’s modulus is commonly used to describe the elastic response of materials. Existing measurement approaches are mainly based on contact loading or large-scale experimental instruments, which may limit excitation controllability and system integration in practical applications. In this work, a Young’s modulus measurement system based on electromagnetic excitation and capacitive sensing is designed and experimentally implemented. The system is composed of an electromagnetic driving unit and a capacitive sensing unit. In the driving unit, a coaxial copper wire coil is arranged with a ring-shaped neodymium–iron–boron permanent magnet assembly. When a square-wave electrical signal is applied, the coil generates a Lorentz force, which produces transient mechanical excitation on the tested sample. The resulting micro-scale deformation of the material surface is monitored using a coaxial passive capacitive sensor. The sensor records the relative capacitance variation (ΔC/C0) induced by deformation during excitation. Based on the measured capacitance response, a force–capacitance coupling model is established to relate the electrical signal to the mechanical behavior of the material, enabling the inverse calculation of Young’s modulus. Commercial standard hardness blocks were used for system calibration and performance verification. The experimentally obtained Young’s modulus values are consistent with reference data within an acceptable deviation range, indicating that the proposed system can be used for quantitative evaluation of elastic properties. Due to its compact configuration and controllable excitation, the system is suitable for non-invasive surface mechanical characterization of soft materials, including biological tissues.
Liu et al. (Fri,) studied this question.