Key points are not available for this paper at this time.
Abstract Dillenia indica is one of the important medicinal plants and is extremely popular in many systems of medicine including ayurvedic, homeopathic, and siddha. Traditionally, different parts of this plant have been used to treat cancer, wound healing, diabetes, diarrhea, bone fractures, abdominal pains, cuts and burns. In the present study, a simple, precise, accurate and validated high performance thin layer chromatographic (HPTLC) method was developed for simultaneous estimation of three pharmaceutically active compounds i.e., betulinic acid (BE), β-sitosterol (BT) and lupeol (LP) in fruits, leaves, root bark and stem bark of D. indica . Standards and plant samples were applied on TLC aluminum plate precoated with 0.2 mm layer of silica gel 60F254. The plate was run in a twin glass chamber comprising toluene:methanol:chloroform (8:1:1, v/v/v) as a mobile phase which resulted in better separation of compounds. The plates were immersed in anisaldehyde-sulfuric reagent and then heated at 105 °C for 5 min in CAMAG TLC plate heater for appearance of bands. Densitometric scanning was performed at λmax = 525 nm using tungsten light source in CAMAG TLC Scanner4 armed with WinCATS software. R F values of BE, BT and LP standards and those of plant samples were found to be 0.38 ± 0.01, 0.54 ± 0.01 and 0.65 ± 0.02 respectively. The method was further validated by following the International Conference of Harmonization (ICH) guidelines. For BE, BT and LP, the linear regression data for the calibration plots revealed a satisfactory linear association with correlation coefficients ( r 2 ) = 0.9736, 0.9989 and 0.9957, respectively. Linear ranges for BE, BT and LP were 2,000–6,000 ng/band, 200–1,000 ng/band, and 200–600 ng/band respectively. Accuracy of the method was assessed by recovery study conducted at three different levels with the average recovery of 99.19, 99.69 and 100.95% for BE, BT and LP, respectively. The results exhibited the highest content of BE (0.148 ± 0.01%), BT (0.031 ± 0.01%) and LP (0.047 ± 0.01%) in stem bark. The developed method will be useful for routine and quality control analysis of fruits, leaves, root bark and stem bark of D. indica species.
Parihar et al. (Tue,) studied this question.