Key points are not available for this paper at this time.
Coastal aquifers, the transition zone between freshwater and saltwater, show large salinity contrasts in the subsurface. Salinity is a key parameter to understand coastal groundwater flow dynamics and consequently also geochemical and microbial processes. For mapping porewater salinity, a variety of methods exists, mainly using electrical conductivity as a proxy. We investigate methods including hydrological/geochemical (well sampling, fluid logger) as well as geophysical method (direct push, geoelectrics) utilising measurements near the high-water line of a high-energy beach at the North Sea island of Spiekeroog. We compare the methods, discuss their benefits and limitations and assess their spatial and temporal resolution. One key to enable a comparison is the estimation of formation factors transforming bulk conductivity measured by geophysical tools in to fluid conductivities obtained from direct measurements. We derive depth-dependent formation factors derived from time-series measurements of fluid loggers and a vertical electrode installation. Using these formation factors, the vertical electrode chain proves to provide reliable salinities at high spatial and temporal dimension. Direct-push profiling data provide the highest vertical resolution. However, a careful calibration is needed to allow for salinity quantification. On the other hand, electrical resistivity tomography (ERT) exhibits the lowest spatial resolution, but can image two-dimensional salinity distributions. We found ERT to fit very well to all other methods, but the data analysis should be aimed at salinities instead of bulk conductivities, i.e. including formation factors and temperature models into the inversion process.
Skibbe et al. (Tue,) studied this question.