Performance Evaluation of Different Rotating Detonation Combustor Designs Using Simulations and Experiments

Abstract Rotating detonation engines (RDEs) present a potential avenue for enhancing the efficiency of gas turbine combustors through the utilization of a detonation-driven process. However, integrating an RDE with a downstream turbine poses a significant challenge due to the shock-laden and highly unsteady nature of the RDE exit flow, coupled with a high degree of flow periodicity. In contrast, gas turbines are designed to operate with relatively small velocity and temperature fluctuations at the turbine inlet. The objective of this study is to develop an understanding of how geometric profiling can improve RDE performance and mitigate exhaust flow field unsteadiness. Three RDE designs are analyzed: an annular combustor with a constant cross-sectional area, an annular combustor with a converging nozzle near the exit, and an annular combustor with a rapid to gradual (RTG) area convergence. Three-dimensional (3D) unsteady reacting simulations are conducted for each configuration using the same fuel-oxidizer composition and mass flow rate condition. All simulations are validated against experimental measurements, and RDE performance is assessed based on total pressure gain/loss, unsteadiness at the exit of the RDE, and detonation effectiveness. Results show significant performance improvement for both the convergent nozzle and the RTG profile compared to the constant cross-sectional area configuration, and the RTG design performed better than the convergent nozzle design. Therefore, strategically constricting the flow in an RDE can be used to optimize the performance of an RDE and should be considered in future designs.