Key points are not available for this paper at this time.
To minimize errors in calculating coal flue gas adsorption capacity due to gas compressibility and to preclude prediction inaccuracies in abandoned mine flue gas storage capacity for power plants, it is imperative to account for the influence of compression factor calculation accuracy while selecting the optimal theoretical adsorption model. In this paper, the flue gas adsorption experiment of a power plant with coal samples gradually pressurized to close to 5 MPa at two different temperatures is carried out, and the temperature and pressure data obtained from the experiment are substituted into five different compression factor calculation methods to calculate different absolute adsorption amounts. The calculated adsorption capacities were fitted into six theoretical adsorption models to establish a predictive model suitable for estimating the coal adsorption capacity in power plant flue gas. Results reveal significant disparities in the absolute adsorption capacity determined by different compression factors, with an error range of 0.001278–7.8262 (cm3/kg). The Redlich–Kwong equation of state emerged as the most suitable for the flue gas of the selected experimental coal sample and the chosen composition ratio among the five compression factors. Among the six theoretical adsorption models, the Brunauer–Emmett–Teller model with three parameters demonstrated the highest suitability for predicting the adsorption capacity of coal samples in power plant smoke, achieving a fitting accuracy as high as 0.9922 at 49.7 °C.
Cheng et al. (Tue,) studied this question.