This paper presents the design and implementation of the Power Stage GAIA (PSG), a high-current digital bias board developed by the Italian National Institute for Astrophysics (INAF) to extend the capabilities of the GAIA bias system. The PSG was developed within the Advanced European THz Receiver Array (AETHRA) project to support next-generation cryogenic receivers for millimeter-wave astronomy. Specifically, the AETHRA Work Package 1 (WP1) W-band downconverter integrates Monolithic Microwave Integrated Circuits (MMICs) requiring currents significantly exceeding the 50 mA limit of standard bias boards. To address these requirements, the PSG introduces a modular extension providing ten independent channels, each capable of delivering up to 500 mA with a programmable output range of 0–5 V. A key feature of the design is the adoption of a fully linear architecture based on LT1970 power amplifiers and INA225 precision sensors managed via an I²C digital interface. This approach ensures the high current capability required by modern power amplifiers while strictly avoiding the spectral noise and Radio Frequency Interference (RFI) typical of switching power supplies. Experimental validation confirms the system’s robustness and precision: the board demonstrated linear operation up to 460 mA and exceptional long-term stability, with a measured RMS voltage deviation below 50 µV. These results establish the PSG as a scalable, low-noise solution suitable for biasing high-power MMICs in future cryogenic receiver arrays.
Ortu et al. (Thu,) studied this question.