Ferronickel slag, as a major solid waste in the stainless-steel industry, poses a serious threat to the environment due to its large-scale production and low utilization rate. In this study, magnesium oxide in the ferronickel slag was leached out and converted into high-purity magnesium sulfate, while the leach residue was utilized for cement clinker production. During the complete utilization of ferronickel slag, the Mg leaching efficiency reached 90.75% and was significantly enhanced by reducing the particle size of the ferronickel slag with H2SO4 solution as the sole solvent. High-purity magnesium sulfate with a purity of 99.92% was prepared from the leachate through a multi-step process involving primary crystallization, purification, and secondary crystallization. The leach residue, accounting for 68.20% of the original mass, was primarily composed of 79.4 wt% SiO2 and less than 6.1 wt% MgO and is used as a key raw material in the production of Portland cement. Sintering temperature significantly influenced the structure and properties of the resulting cement. Both the Portland clinker and cement were successfully produced at sintering temperatures of 1400 °C and 1450 °C when the leach residue was used as a primary raw material, with well-developed cementitious phases of calcium silicate and aluminate formed during calcination. The setting time, soundness, and compressive and flexural strengths of the hardened C1400 and C1450 mortars met the requirements specified in relevant standards. Through this integrated process, the overall utilization rate of the ferronickel slag reached 100%. Based on a preliminary estimate, full utilization of the annual ferronickel slag production in China could substitute at least 19.5 million tons of magnesite and 15.0 million tons of silica and reduce CO2 emissions by 10.3 million tons.
Lei et al. (Thu,) studied this question.