AbstractBackground The impact of burr speed on rotational atherectomy (RA) mechanical efficacy remains debated. We aimed to analyze the effect of different RA protocols on postinterventional luminal gain. Methods Procedures were performed in vitro on proximal left anterior descending artery with a 1.75-mm burr in a 3-dimensional–printed beating heart model. All lesions first underwent a high speed (HS; 180,000 revolutions per minute) pecking run followed by a HS polishing run of 30 seconds. This standard technique was completed by additional 30-second low speed (LS; 110,000 revolutions per minute) runs as follows: 1 (LS short group, n=28 lesions); 2 (LS midgroup, n=30 lesions), or 3 additional LS runs (LS long group, n=27 lesions), while the control group (n = 27 lesions) received no additional polishing. An additional HS long group in which 3 additional 30-second HS polishing runs were delivered following the initial standard steps was also created (n = 27 lesions). The specimens were analyzed by microcomputed tomography scan to measure the average luminal volume (ALV) and minimal cross-section area. Results The baseline lesion ALV and minimal cross -section area were and 128.57 mm3 and 1.56 mm2, respectively. The final ALV was significantly higher in LS short (median, 158.9 mm3 IQR, 150.0-164.9), LS mid (median, 156.4 mm3 IQR, 147.1-167.1), LS long (median, 157.1 mm3 IQR, 151.0-166.2), and HS long groups (median, 156.6 mm3 IQR, 149.0-169.9) than control specimens (median, 146.8 mm3 IQR, 137.5-157.3: P Conclusions These data suggest that additional polishing runs after standard RA procedure improves the debulked lesion volume, regardless of burr speed.
Amabile et al. (Sun,) studied this question.