Key points are not available for this paper at this time.
A solution that enables safe, efficient, and convenient overnight recharging of electric vehicles is needed. Inductive power transfer (IPT) is capable of meeting these needs, however, the main limiting factor is the performance of the magnetic structures (termed power pads) that help transfer power efficiently. These should transfer 2-5 kW with a large air gap and have good tolerance to misalignment. Durability, low weight, and cost efficiency are also critical. 3-D finite-element analysis modeling is used to optimize circular power pads. This technique is viable, since measured and simulated results differ by 10% at most. A sample of power pads was considered in this work, and key design parameters were investigated to determine their influence on coupled power and operation. A final 2 kW 700-mm-diameter pad was constructed and tested having a horizontal radial tolerance of 130 mm (equivalent to a circular charging zone of diameter 260 mm) with a 200 mm air gap. The leakage magnetic flux of a charging system was investigated via simulation and measurement. The proposed pads meet human exposure regulations with measurement techniques specific by the Australian Radiation Protection and Nuclear Safety Agency (ARPANSA) which uses the International Commission on Non-Ionizing Radiation Protection (ICNIRP) guidelines as a foundation.
Budhia et al. (Thu,) studied this question.