This paper presents an iterative graph-analytical procedure for determining the roll center height, one of the most critical design parameters influencing vehicle dynamic behavior during cornering. The conventional approaches generally determine roll center locations from suspension kinematics and then evaluate vehicle behavior using multibody or numerical vehicle dynamics models. By contrast, the proposed method is intended for the preliminary design stage and provides a direct correlation between front and rear target roll center heights using tire test data, load transfer and axle-level equilibrium conditions. The main advantage of the method is that it helps define a feasible design space before detailed geometry optimization or MBD validation is performed. The objective is to achieve stable and neutral handling (avoiding intrinsic understeer or oversteer tendencies) during steady-state cornering at a predefined target lateral acceleration. The methodology integrates (i) lateral force equilibrium at the axle level, (ii) a dynamic load transfer model based on axle roll stiffness and roll center heights, and (iii) experimental tire grip characteristics (lateral force–slip angle curves under varying vertical loads), processed through numerical interpolation. The procedure is demonstrated using a vehicle model with specific geometric and mass parameters. The results indicate that the methodology does not yield a single unique solution, but rather a set of correlated roll center heights, allowing the designer to select the most feasible geometric configuration while maintaining neutral handling. As an example, the paper presents a convergent solution for the front and rear roll center heights that satisfy neutrality conditions at a slip angle of approximately 4°. This study provides a fundamental framework for the geometric design of suspension systems and serves as a basis for subsequent numerical and experimental validation.
Botu et al. (Fri,) studied this question.