Key points are not available for this paper at this time.
Initial defects, for example, those occurring during the production of a rotor blade, encourage early damages such as rain erosion at the leading edge of wind turbine rotor blades. To investigate the potential that initial defects have for early damage, long-pulse thermography as a non-destructive and contactless measurement technique is applied to a strongly curved and coated test specimen for the first time. This specimen is similar in structural size and design to a rotor blade leading edge and introduced with sub-surface defects whose diameters range between 2mm and 3.5mm at depths between 1.5mm and 2.5mm below the surface. On the curved and coated test specimen, sub-surface defects with a depth-to-diameter ratio of up to 1.04 are successfully detected. In particular, defects are also detectable when being observed from a non-perpendicular viewing angle, where the intensity of the defects decreases with increasing viewing angle due to the strong surface curvature. In conclusion, long-pulse thermography is suitable for the detection of sub-surface defects on coated and curved components and is therefore a promising technique for the on-site application during inspection of rotor blade leading edges.
Jensen et al. (Thu,) studied this question.