Freshwater scarcity is driving the construction industry to seek alternative mixing waters, and seawater is an abundant resource; however, its suitability is commonly judged by total salinity, which overlooks the fact that coastal seawater chemistry varies hugely between locations and may govern long-term strength performance in varying locations. To address this problem, this study investigates the long-term strength performance and its microstructural and phase transformation of cement mortars mixed with seawater, with the aim of establishing a technical understanding between region-specific seawater chemistry and mortar strength. Seawater was collected from four coastal locations in Tamil Nadu, India, and characterized for chloride, sulfate, magnesium, organic solids, and related parameters. The cement mortar cubes were cast with each seawater, and compressive strength was measured from 3 to 360 days; the microstructural and phase changes underlying the strength behavior were examined at 360 days using Scanning Electron Microscopy (SEM) and X-ray Diffraction (XRD). All samples showed accelerated early-age strength gain from the catalytic effect of chloride and sulfate ions, followed by strength loss at later ages caused by the same ionic environment, with a critical strength loss between 28 and 56 days. The Chennai sample, with the highest chloride and sulfate concentrations, suffered the most severe degradation of 11.5% loss of peak strength, which is attributed to ettringite and gypsum formation together with magnesium attack that consumed Portlandite to form non-cementitious brucite and secondary Calcite. In contrast, the Rameshwaram sample, with exceptionally low sulfate, exhibited superior stability with 3.5% loss, while Puducherry and Tuticorin showed intermediate degradation of 3.9% and 7.8% respectively, with the Puducherry sample further compromised by high organic solids. The results identify the chloride to sulfate ratio, rather than total salinity, as the key predictor of long-term strength performance. The main takeaway for the cement industry is that the suitability of seawater as mixing water is highly site-specific, and a detailed chemical analysis quantifying sulfate and magnesium content is an indispensable prerequisite for strength assessment and material selection before seawater is adopted in marine and coastal construction.
Karthikeyan et al. (Thu,) studied this question.