Key points are not available for this paper at this time.
For the removal of hexavalent chromium Cr (VI) from drinking water, a hybrid biosorbent designated chitosan–natural diatomaceous earth (CNDE) was developed and thoroughly characterized. The material couples the ion-exchange and chelating capacity of chitosan—applied at an 85% degree of deacetylation—with the high-surface-area mineral framework of natural diatomaceous earth, onto which the polymer was deposited as a conformal coating. Surface morphology and internal microstructure were examined by scanning and transmission electron microscopy (SEM/TEM), while elemental composition across the hybrid matrix was resolved by energy-dispersive X-ray spectroscopy (EDX). Fourier transform infrared (FTIR) spectroscopy was employed to identify the surface functional groups responsible for chromate binding, and streaming current measurements established the pH of zero charge (pHₚzc), which governs the electrostatic environment at the sorbent–solution interface. Specific surface area was quantified by the Brunauer–Emmett–Teller (BET) method, and the balance of surface acidic and basic sites was determined through titrimetric analysis of total acidity and alkalinity. Thermogravimetric analysis (TGA) was conducted to assess thermal stability. Batch equilibrium isotherm experiments were performed to evaluate Cr (VI) uptake from model drinking water prepared using dilute potassium dichromate solutions adjusted to target pH levels. The effects of solution pH and competing anions (chloride and sulfate) were also investigated. Kinetic studies were conducted to determine the rate of Cr (VI) adsorption, and residual metal concentrations were measured using inductively coupled plasma mass spectrometry (ICP-MS). Results indicated that CNDE containing 30% chitosan (CNDE30) achieved effective Cr (VI) removal at pH 5. Adsorption was strongly pH-dependent, decreasing as pH increased from 5 to 8. Equilibrium data were well described by both Langmuir and Freundlich isotherm models, while kinetic data followed a pseudo-second-order model. The presence of chloride ions (15 mg/L) reduced adsorption capacity by approximately one-third, whereas sulfate at the same concentration significantly inhibited Cr (VI) removal. Overall, the isotherm results suggest that CNDE30 is a promising material for Cr (VI) removal from drinking water. Its cost-effectiveness, ease of synthesis, and potential for reuse make it particularly attractive for small-scale and decentralized water treatment applications.
Koumai et al. (Thu,) studied this question.