Key points are not available for this paper at this time.
The spring-mass model, representing a runner as a point mass supported by a single linear leg spring, has been a widely used concept in studies on running and bouncing mechanics. However, the measurement of leg and vertical stiffness has previously required force platforms and high-speed kinematic measurement systems that are costly and difficult to handle in field conditions. We propose a new "sine-wave" method for measuring stiffness during running. Based on the modeling of the force-time curve by a sine function,this method allows leg and vertical stiffness to be estimated from just a few simple mechanical parameters: body mass, forward velocity, leg length, flight time, and contact time. We compared this method to force-platform-derived stiffness measurements for treadmill dynamometer and overground running conditions, at velocities ranging from 3.33 m.s-1 to maximal running velocity in both recreational and highly trained runners. Stiffness values calculated with the proposed method ranged from 0.67 % to 6.93 % less than the force platform method, and thus were judged to be acceptable. Furthermore, significant linear regressions (p < 0.01) close to the identity line were obtained between force platform and sine-wave model values of stiffness. Given the limits inherent in the use of the spring-mass model, it was concluded that this sine-wave method allows leg and stiffness estimates in running on the basis of a few mechanical parameters, and could be useful in further field measurements.
Morin et al. (Sun,) studied this question.