Key points are not available for this paper at this time.
The fracture surfaces of specimens of a heat‐treated hard steel, namely Cr–Mo steel SCM435, which failed in the regime of N = 105 to 5 × 108 cycles, were investigated by optical microscopy and scanning electron microscopy (SEM). Specimens having a longer fatigue life had a particular morphology beside the inclusion at the fracture origin. The particular morphology looked optically dark when observed by an optical microscope and it was named the optically dark area (ODA). The ODA looks a rough area when observed by SEM and atomic force microscope (AFM). The relative size of the ODA to the size of the inclusion at the fracture origin increases with increase in fatigue life. Thus, the ODA is considered to have a crucial role in the mechanism of superlong fatigue failure. It has been assumed that the ODA is made by the cyclic fatigue stress and the synergetic effect of the hydrogen which is trapped by the inclusion at the fracture origin. To verify this hypothesis, in addition to conventionally heat‐treated specimens (specimen QT, i.e. quenched and tempered), specimens annealed at 300 °C in a vacuum (specimen VA) and the specimens quenched in a vacuum (specimen VQ) were prepared to remove the hydrogen trapped by inclusions. The specimens VA and VQ, had a much smaller ODA than the specimen QT. Some other evidence of the influence of hydrogen on superlong fatigue failure are also presented. Thus, it is concluded that the hydrogen trapped by inclusions is a crucial factor which causes the superlong fatigue failure of high strength steels.
MURAKAMI et al. (2000) studied this question.