Synthesis of quantum-logic circuits

The pressure of fundamental limits on classical computation and the promise of exponential speedups from quantum effects have recently brought quantum circuits (Proc. R. Soc. Lond. A, Math. Phys. Sci., vol. 425, p. 73, 1989) to the attention of the electronic design automation community (Proc. 40th ACM/IEEE Design Automation Conf., 2003), (Phys. Rev. A, At. Mol. Opt. Phy., vol. 68, p. 012318, 2003), (Proc. 41st Design Automation Conf., 2004), (Proc. 39th Design Automation Conf., 2002), (Proc. Design, Automation, and Test Eur., 2004), (Phys. Rev. A, At. Mol. Opt. Phy., vol. 69, p. 062321, 2004), (IEEE Trans. Comput.-Aided Des. Integr. Circuits Syst., vol. 22, p. 710, 2003). Efficient quantum-logic circuits that perform two tasks are discussed: 1) implementing generic quantum computations, and 2) initializing quantum registers. In contrast to conventional computing, the latter task is nontrivial because the state space of an n-qubit register is not finite and contains exponential superpositions of classical bitstrings. The proposed circuits are asymptotically optimal for respective tasks and improve earlier published results by at least a factor of 2. The circuits for generic quantum computation constructed by the algorithms are the most efficient known today in terms of the number of most expensive gates quantum controlled-NOTs (CNOTs). They are based on an analog of the Shannon decomposition of Boolean functions and a new circuit block, called quantum multiplexor (QMUX), which generalizes several known constructions. A theoretical lower bound implies that the circuits cannot be improved by more than a factor of 2. It is additionally shown how to accommodate the severe architectural limitation of using only nearest neighbor gates, which is representative of current implementation technologies. This increases the number of gates by almost an order of magnitude, but preserves the asymptotic optimality of gate counts.