Key points are not available for this paper at this time.
Fast, continuous, 3D printing Although three-dimensional (3D) printing is now possible using relatively small and low-cost machines, it is still a fairly slow process. This is because 3D printers require a series of steps to cure, replenish, and reposition themselves for each additive cycle. Tumbleston et al. devised a process to effectively grow solid structures out of a liquid bath. The key to the process is the creation of an oxygen-containing “dead zone” between the solid part and the liquid precursor where solidification cannot occur. The precursor liquid is then renewed by the upward movement of the growing solid part. This approach made structures tens of centimeters in size that could contain features with a resolution below 100 µm. Science , this issue p. 1349
Building similarity graph...
Analyzing shared references across papers
Loading...
John R. Tumbleston
David Shirvanyants
Nikita Ermoshkin
Science
University of North Carolina at Chapel Hill
North Carolina State University
Building similarity graph...
Analyzing shared references across papers
Loading...
Tumbleston et al. (Mon,) studied this question.
www.synapsesocial.com/papers/69d8543005ee2ba81dbef913 — DOI: https://doi.org/10.1126/science.aaa2397
Synapse has enriched 5 closely related papers on similar clinical questions. Consider them for comparative context: