Key points are not available for this paper at this time.
The class E tuned power amplifier consists of a load network and a single transistor that is operated as a switch at the carrier frequency of the output signal. The most simple type of load network consists of a capacitor shunting the transistor and a series-tuned output circuit, which may have a residual reactance. Circuit operation is determined by the transistor when it is on, and by the transient response of the load network when the transistor is off. The basic equations governing amplifier operation are derived using Fourier series techniques and a high- Q assumption. These equations are then used to determine component values for optimum operation at an efficiency of 100 percent. Other combinations of component values and duty cycles which result in 100-percent efficiency are also determined. The harmonic structure of the collector voltage waveform is analyzed and related amplifier configurations are discussed. While this analysis is directed toward the design of high-efficiency power amplifiers, it also provides insight into the operation of modern solid-state VHF-UHF tuned power amplifiers.
Frederick H. Raab (Thu,) studied this question.