Assessment of the tectonically induced Quaternary landforms and active deformation in the area between Main Boundary Thrust and Himalayan Frontal Thrust, south of the Siang Antiform, Arunachal Himalaya, India

The present study area represents one of the active segments of the frontal part of the Arunachal Himalaya. The major structural boundaries traversing the area are the Main Boundary Thrust (MBT) and the Himalayan Frontal Thrust (HFT) and other local faults are tectonically active, as evident from the landforms that evolved in the fault zones. Strath terraces and uplift fluvial terraces are observed in the hanging‐wall block of the HFT and MBT, and along the HFT straight to curvilinear mountain fronts are observed. Normal faults both transverse and parallel to the strike of HFT are observed in the hanging‐wall block of the HFT. West of Pasighat the sub‐Himalaya terrain resembles a duplex, where there is gradual rise in elevation from the Brahmaputra Plain to the low‐lying hills of the sub‐Himalayan and sudden rise in elevation across the MBT. Drainage aligning to the bedrock structures and stream migrations are observed in the fault zones. Along the MBT, the sub‐Himalayan rocks are thrusted over either by quartzite or black carbonaceous shales, in some sections the MBT is behaving as a back‐thrust that dips towards the south. The MBT has also been displaced by almost N–S‐trending transverse faults where highly sheared bedrocks are also observed. Tilting of Quaternary fluvial deposits are observed in the hanging‐wall blocks of intraformational thrusts at two locations. Signatures of paleoseismic activities in the form of various soft‐sediment deformational structures are observed in Quaternary deposits in the HFT zone and also in the hanging‐wall block of the MBT. To determine the deformation and strain rate accumulation, we have re‐analysed the available GNSS results of the area, which indicate a deformation rate of up to 16 mm/year in the vicinity of the Pasighat region. The GPS‐derived deformation rates are well corroborated with the existing results of peak ground acceleration (PGA) anomalies. The component–wise motion indicates higher fault perpendicular motion in this part, which reveals an accumulation of more strain along the major Himalayan faults.