Key points are not available for this paper at this time.
Previous projects on CO2 storage in coal often reported the challenges associated with coal swelling and swelling-induced loss of gas injectivity. Since coal seams are typically thin, commonly used vertical wells only intersect a target reservoir over a small contact area, placing constraints on CO2 injectivity in addition to those resulting from coal swelling. This leaves the storage reservoirs largely under-utilized and, therefore, questions the viability of this technology. To address the challenges/limitations of the current practice, a novel in-situ CO2 injection test is planned using horizontal injection wells in Mikolow, Poland. This paper presents the pre-operational simulation studies conducted to assist the design and operation of the in-situ test. An existing dual-porosity model that is built on a coupled thermo-hydro-chemical-mechanical (THCM) modelling framework is employed in this study. Sensitivity of the model parameters and validity of the model are tested. Several simulation scenarios are developed in reference to the selected test site for various horizontal well configurations and gas injection conditions. From the results and analyses, it is evident that by varying the coal-CO2 contact area via the length of the horizontal injection well, as well as the operating conditions including fixed pressure, and fixed rate injection scenarios, the targeted amount (between 1 to 10 tonnes) of CO2 can be injected into the seam without significant loss of permeability or injectivity, yielding sustained gas injection. Moreover, the spread of CO2 is predicted to be contained within the model domain suggesting no significant concern of spread exceeding the test area.
Masum et al. (Wed,) studied this question.