Key points are not available for this paper at this time.
Additive manufacturing using two-photon polymerization (TPP) lithography is increasingly used in industry and research. Parameter sweeps of cuboid structures fabricated using TPP lithography were investigated across the parameters of the laser power and scan speed to find dependent mechanical material properties. The employed photoresists were examined using Raman spectroscopy to find the degree of conversion (DC) of monomer to polymer, and subsequently, micro- or nanoindentation was used to find Young’s modulus (E). For the photoresist IP-Dip, the attained DC and E ranged from 20% to 45% and 1 to 2.1 GPa, respectively. The results were compared with reports found in the literature. For IP-Q, the attained DC and E ranged from 53% to 80% and 0.5 to 1.3 GPa, respectively. The characterized properties of IP-Q manifest as the current state of knowledge of the material.
Schweiger et al. (Wed,) studied this question.