CBCT Analysis of Dento-Skeletal Changes after Rapid versus Slow Maxillary Expansion on Deciduous Teeth: A Randomized Clinical Trial

The aim of the present study was to compare skeletal and dental changes after rapid maxillary expansion (RME) and slow maxillary expansion (SME) performed by a Leaf Expander (LE) with upper deciduous teeth as anchorage and using 3D CBCT (Cone Beam Computed Tomography) analysis. Mixed dentition patients were randomly divided in two groups, according to the different expansion used anchored on maxillary primary second molars: the RME group (n = 16) was treated with a Hyrax type expander, whereas the SME group (n = 16) was treated with an LE expander. CBCT scans were performed before (T1) and after treatment (T2) and analyzed with a custom landmarks system. A paired t-test was used for intragroup analysis between T1 and T2, and a Student t-test was used for intergroup analysis; statistical significance was set at 0.05. Both RME and SME groups showed a statistically significant increase in dental and skeletal diameters. Group comparisons between T1 and T2 showed a significant expansion rate in the RME group for upper permanent molars (p = 0.025) but not for deciduous molars (p = 0.790). Moreover, RME showed higher increases for skeletal expansion evaluated at nasal walls (p = 0.041), whereas at pterygoid plates did not show any significant differences compared with the SME group (p = 0.849). A significant transverse expansion could be achieved with the expander anchored on deciduous teeth. RME and SME produced effective both skeletal and dentoalveolar transverse expansion; RME produced more anterior expansion than SME but less control regarding the permanent molar decompensation. SME by LE therefore could be an efficient and helpful alternative in the treatment of transverse maxillary deficiency in growing patients.