Key points are not available for this paper at this time.
Abstract High‐moisture pelleting of corn stover was tested in pilot‐ and commercial‐scale systems. For the pilot‐scale study, a 6.35 mm screen size hammer mill ground corn stover was reconditioned to moisture between 14 and 29.6% (w.b.), and 5, 7 and 9 L / D ratio pellet die were used. At 29% corn stover moisture content and L / D ratios of 5 and 9, the bulk density and durability of the pellets were ≤450 kg/m 3 and 540 kg/m 3 and >90%, respectively. Increasing the feedstock moisture and L / D ratio increased the pelleting energy. Increasing the hammer mill screen size to 11.11 mm reduced the bulk density but not the durability. The response surface models adequately described the pelleting process ( R 2 ≥ 0.88), and analysis of variance showed a strong interaction between the process variables and pellet properties. Commercial‐scale testing of high‐moisture pelleting using 6.35 mm ground corn stover bales in the moisture range 24–26% (w.b.) produced pellets with a density of >675 kg/m 3 and durability of >98%, whereas increasing the hammer mill screen size to 11.11 mm reduced the bulk density by about 100 kg/m 3 but not the durability. The energy consumption of the commercial‐scale unit operations for the high‐moisture pelleting process was in the range 98–124 kW h/ton, which is 64–72% less energy than conventional pelleting that requires energy about 350 kW h/ton for biomass drying from 30% (w.b.) to 10% (w.b.) moisture content before pelleting. Pellets produced using high‐moisture pelleting met International Organization for Standardization and Pellets Fuel Institute international standards. Published 2023. This article is a U.S. Government work and is in the public domain in the USA.
Jaya Shankar Tumuluru (2023) studied this question.