Key points are not available for this paper at this time.
Purpose The purpose of this study was to investigate the likely causes of failure of some sections of road pavements in Ajaokuta, Northcentral Nigeria. This was achieved through a geotechnical assessment of subgrade soils in affected areas. Design/methodology/approach The methods entailed field and laboratory methods and statistical analysis. Subgrade soil samples were retrieved from a depth of 1,000 mm beneath the failed portions using a hang auger. The soils were analyzed for natural moisture content (NMC), Atterberg limit (liquid limit, plastic limit and linear shrinkage), grain size distribution, compaction and California bearing ratio (CBR), respectively. Findings The results of the geotechnical tests ranged from NMC (12.5%–19.4%), sand (84%–98%), fines (2%–16%), LL (16.0%–32.2%), PL (17%–27.5%), LS (2.7%–6.4%), PI (2.5%–18.4%), maximum dry density (1756 kg/m2–1961 kg/m2), optimum moisture content (13.2%–20.2%), unsoaked CBR (15.5%–30.5%) and soaked CBR (8%–22%), respectively. Pearson’s correlation coefficient performed on the variables showed that some parameters exhibited a strong positive correlation with r 2 > 0.5. Research limitations/implications Funding was the main limitation. Originality/value Comparing the results with Nigerian standards for road construction, and the AASHTO classification scheme, the subgrade soils are competent and possess excellent to good properties. The soils also exhibited very low plasticity, a high percentage of sand, high CBR and low NMC, which implies that it has the strength required for road pavement subgrades. The likely causes of the failures are, therefore, due to the use of poor construction materials, technical incompetence and poor compaction of sub-base materials, respectively.
Akudo et al. (Sat,) studied this question.